Miele dryer repair

• Runs a full cycle but clothes are still damp

  Restricted venting first, then a failed heating element or gas valve coil. A load that takes two cycles is the early warning.

• No heat at all

  Thermal fuse, heating element, high-limit thermostat or, on gas models, the igniter and valve coils.

• Drum will not turn

  A snapped drive belt is the usual answer, and it is a quick fix. Seized idler pulleys and drum rollers come next.

• Squealing or thumping while it runs

  Drum rollers, the idler pulley or the rear drum bearing. Worth doing early: a collapsed roller can score the drum.

• Dryer shuts off partway through

  A thermal cutoff opening under heat, usually because the vent is restricted and the cabinet is overheating.

• Burning smell during a cycle

  Stop the machine and unplug it. This is lint against a heating element or a seized motor, and both need attention before the next load.

• Acton, MA
• Andover, MA
• Arlington, MA
• Bedford, MA
• Belmont, MA
• Beverly, MA
• Billerica, MA
• Boston, MA
• Braintree, MA
• Brockton, MA
• Brookline, MA
• Brookline, NH
• Burlington, MA
• Cambridge, MA
• Chelmsford, MA
• Chelsea, MA
• Clinton, MA
• Concord, MA
• Danvers, MA
• Dedham, MA
• Derry, NH
• Dracut, MA
• Everett, MA
• Framingham, MA
• Gloucester, MA
• Haverhill, MA
• Hingham, MA
• Hudson, MA

• Thank you so much! Great customer service. Came and fixed our washer, looks good as new! Hire him

• Tim was very professional and did his job correctly but was sent a defective part. Ramin came and replaced the defective part and my stove works again. After an initial problem that wasn't their fault, masterfix did an excellent job. I would not hesitate to use them again. Thanks Tim and Ramin!

• My dryer was fixed immediately and the contractor gave me filter change recommendations. However, it was not cheap.

Read all reviews on Thumbtack

What goes wrong with Miele dryers?

Dishwasher circulation pumps is the fault we attend most on this combination. Miele designs for twenty years of service and prices its parts accordingly. Their dishwashers and washing machines are among the few appliances where a major repair at year fifteen still makes sense.

How often should the vent be cleaned?

Once a year for a typical household, and more if the run is long, has several elbows, or you dry heavy loads. If a cycle has quietly stretched from 45 minutes to 90, the vent is the first thing to check.

Gas or electric, does it change the repair?

It changes the heat source, not the rest of the machine. Gas dryers add an igniter, a flame sensor and valve coils; belts, rollers and thermostats are the same on both.

Can a blocked vent damage the dryer?

Yes. Trapped heat repeatedly trips the high-limit thermostat and eventually kills the element or the control board. Clearing the vent protects the repair you just paid for.

Do you carry Miele parts for this?

We stock the common failures listed on this page. Anything model specific is ordered after the diagnosis, and we tell you the wait before you commit. Every part carries 90 days of warranty.